Instruction Manual 3 in 1 Sandwich Maker E27002 220V~240V 50Hz 640W -740W

Instruction Manual
3 in 1 Sandwich Maker
220V~240V 50Hz 640W -740W
V1.1 01-2010
This product is guaranteed for 12 months from the date of the original purchase. If any defect
arises due to faulty materials or workmanship the faulty products must be returned to the
place of purchase. Refunds or replacement is at the discretion of the store.
The following conditions apply:
• The product must be returned to the retailer with the original proof of purchase.
• The product must be installed and used in accordance with the instructions contained
in this instruction guide.
• It must be used only for domestic purposes.
• It does not cover wear and tear, damage, misuse or consumable parts.
• PFD has no responsibility for incidental or consequential loss or damage.
• Valid in the UK and Eire only.
Technical Specification
AC: 220V~240V 50Hz 640W-740W
3 Inter Changeable Heating Plates.
Link House, Bute Street,
Fenton, Stoke On Trent,
Staffordshire,ST4 3PR
Power cable
Power and temperature lights
Removable plates
Included with the Sandwich Maker
1X Set of waffle plates.
1X set of sandwich toaster plates
1X Set of plates
Please read this leaflet carefully before you start to use your Sandwich Maker. It will enable
V1.1 01-2010
you to get the most out of your new product and to safely enjoy its many benefits.
Check that the voltage marked on the product corresponds with your supply voltage.
In common with other electrical appliances, the product must not used in wet or damp
Do not immerse the product in water.
Never touch the plug or use the unit with wet hands.
Always unplug the unit before cleaning, moving or when not in use.
Examine the product for wear and tear regularly.
Do not use the unit if you see any signs of damage. Should damage be found the unit should
be inspected and tested by a qualified electrician.
This product is not intended for use by children or the infirm without adequate supervision
Keep out of the reach of children.
The unit will get hot whilst in use – Be careful when using it.
Always use the handle.
Do not overfill the sandwich maker – as this may damage the product.
Do not use on or near hot appliance or surfaces.
Ensure the unit is on a dry level surface before use.
Position the unit in a suitable place as steam may be emitted from the ingredients when in
Use care on opening and closing the unit.
Before using the sandwich maker for the first time, wipe both the interior and exterior with a
slightly damp cloth or kitchen paper.
Then to enhance the non-stick performance of the sandwich maker plates, rub the plates with
a little butter or margarine that is suitable for frying.
Switch on the unit.
When using for the first time, the sandwich maker may emit a little smoke – this is normal.
This is due to the plates “curing” and will stop after a short time. Following the first two steps
will help reduce this.
There are two lights on the sandwich maker. The red light indicates that the power is on and
the green light indicates that the unit is heating. When the sandwich maker is up to cooking
temperature, the green “ready” light will go out. This light will cycle on and off whilst in use –
to keep a constant cooking temperature.
For best results, wait until the unit is up to temperature before cooking. This will give crispier
Plug in the sandwich maker so that the unit is heating whilst you prepare your sandwiches.
Spread the bread for the sandwiches evenly with butter or margarine suitable for frying. This
will prevent the sandwich sticking to the plates.
With the buttered side of the bread on the outside of the sandwich – fill your sandwich with
the desired ingredient. Be careful not to overfill the sandwich, as forcing the unit closed may
damage the appliance.
When the “ready” light has switched off, carefully place the sandwich in the unit.
Close the lid and secure with the catch on the handle.
Your sandwich will normally take between 3-5 minutes to cook depending on your taste and
the ingredients. Remove the sandwich with a wooden utensil (so as not to damage the non
stick surface).
Checking: Leave the sandwich to cook for about 2 minutes to allow it to seal before checking
if the desired “browning” has been reached.
Warning: The sandwich filling will be very hot!! Use care when eating and especially when
serving to children.
V1.1 01-2010
Make a batter mix
Add oil to the waffle maker and allow to heat.
Pour in the batter mix and allow to cook until golden brown and firm
Serve whilst still hot on their own or with a topping of your choice
Oil the plates before use.
Place the food onto the grill close the lid and allow to cook.
It is advisable to turn the food during cooking.
Ensure that the food is thoroughly cooked and is served piping hot before serving.
Always ensure that all food cooked and is piping hot before serving.
Only use pre-cooked meats / fish in the sandwich maker as raw meats / fish may not be
cooked thoroughly within the cooking time.
You can choose many different ingredients as fillings for your sandwiches, here are some
typical favorite ingredients. You can experiment with your own favorite combinations!
Cheese, ham, salami, bacon, chicken, tuna, tomatoes, mushrooms, onions, sweet corn,
pickles, egg, banana, apple or strawberry.
Do not immerse the appliance in water or any other liquid.
Before cleaning, unplug the sandwich maker from the power supply and allow to cool
Wipe the exterior of the sandwich maker with a slightly damp cloth or kitchen paper to keep it
clean, ensuring that no excess moisture enters the main body of the unit.
The interior of the sandwich maker has a non-stick surface. Only clean with a slightly damp
cloth or kitchen paper (ensuring no excess moisture enters the main body).
Never use cleaning agents, abrasive materials or sharp implements to clean the plates inside
the sandwich maker, as this will damage both the finish and performance of the unit.
V1.1 01-2010
Electrical Safety
Class 1 Configuration
The wires in the mains lead are coloured in accordance with the
following code:
Class 1 Configuration
As the colours of the wires in the mains lead of this appliance may not correspond with the coloured
markings identifying the terminals in your plug, proceed as follows:
The wire which is coloured GREEN & YELLOW (or coloured GREEN) must be connected
to the terminal in the plug which is marked with the letter “E” or by the earth symbol
The wire which is coloured BLUE (or coloured BLACK) must be connected to the
NEUTRAL terminal which is marked with the letter “N”.
The wire which is coloured BROWN (or coloured RED) must be connected to the LIVE
terminal which is marked with the letter “L”.
Always ensure that the Mains Cord is fixed into the plug through the Cord Guard or Cable Clamp,
(plug wiring diagram above), and that the Cord Guard screws are tightened to clamp the cord (outer
sheath and inner coloured wires) into position in the plug. Make sure that the plug top is also fitted
This appliance must be protected by a 13 Amp fuse in a 13 Amp type (BS1363) plug. Should you
need to replace the fuse, use only a 13Amp ASTA approved BS1362 fuse (13A).
It is important to ensure the correct Plug Adaptor is used when operating in a country not using the
UK 13 Amp socket system. If in doubt, consult a qualified electrician.
Disposal of Unit
Disposal instructions for Elgento items in accordance with the WEEE directive.
Appliances bearing the symbol shown here may not be disposed of in domestic
rubbish. You are required to dispose of old electrical and electronic appliances
visit, for access to information about the recycling of electrical
items. The WEEE directive, introduced in August 2006, states that all electrical
items must be recycled, rather than taken to landfill. Please arrange to take this
appliance to your local Civic Amenity site for recycling, once it has reached the
end of its life.
Imported & Distributed throughout the U.K. PFD ST4 3PR
V1.1 01-2010