ALBEDO Ether.Sync Datasheet

in Test we Trust
ALBEDO Ether.Sync is a field tester that supports absolutely all Ethernet standards
and functionalities you need to install, commission and troubleshoot telecom services based on GbE, SyncE, PTP, Jitter and Wander.
ALBEDO Ether.Sync
Ether.Sync is a field instruments for testing the new LTE architectures, Synchronization planes, and Gigabit Ethernet networks the need of modules because everything is embedded
in this modern hand-held units.
• SFP ports: 1000BASE-T, 1000BASE-SX, 1000BASE-LX,
INTERFACES
1.1.
1000BASE-ZX, 1000BASE-BX, 100BASE-TX
• Port A - B: 2 x SFP, 2 x RJ45 connectors
• Port C - D: balanced, RJ45 120 Ω, unbalanced BNC 75 Ω
• Analogue voice frequency Port
• RJ-45 ports: 100BASE-TX, 1000BASE-T
2.3.2 Timing
• Internal, external or recovered clock in Ethernet interfaces
• Freq offset generation up to ±125 ppm (res. 0.001 ppm)
• Line freq (MHz), offset (ppm), drift (ppm/s)
OPERATION MODES
1.2.
TCP/IP
Ethernet
End-point
YES
YES
Monitor
YES
YES
Pass-through
YES
YES
Loop-back
YES
YES
2. ETHERNET PHY
2.3.3 Synchronization
• Frequency offset generation of ±120 ppm
• Sinusoidal wander generation
• ESMC, SSM, QL: generation, decoding, forwarding
3. ETHERNET MAC
•
•
•
•
•
•
•
•
INTERFACES
• SFP ports: 1000BASE-T, 1000BASE-SX, 1000BASE-LX,
•
•
•
1000BASE-ZX, 1000BASE-BX, 100BASE-FX,
100BASE-TX, 10BASE-T
RJ-45 ports: 10BASE-T, 100BASE-TX, 1000BASE-T
On / Off laser control
Insertion of code errors
2.1.1 Auto-Negotiation
• Bit rate: 10 Mbit/s, 100 Mbit/s, 1 Gbit/s
• Master and Slave roles in the 1000BASE-T
• Disable auto-negotiation, force line settings
• Interfaces: 10BASE-T, 100BASE-T, 1000BASE-TX
• PoE pass-through in transparent mode
TIME REFERENCES
•
•
•
•
Internal time ref < ±3.0 ppm (Optionally < ±0.1 ppm)
Ethernet through Port A & B
2048 Mbit/s, 2048 MHz, 1544 Mbit/s, 1544 MHz Port C
10 MHz, 2 Mbit/s, 2 MHz, 1.5 Mbit/s, 1.5 MHz Datacom Port
Formats: DIX, IEEE 802.3, IEEE 802.1Q, IEEE 802.1ad
Jumbo frames up to 10 kB
Sour / Dest MAC address setting
Type / Length Setting
Enable / Disable VLAN and Q-in-Q modes
VLAN VID / User Priority setting
S-VLAN VID, DEI, PCP, C-VLAN VID, User Priority
FCS errors insertion
4. IP
IPV4
4.1.
•
•
•
•
2.1.2 Power over Ethernet (PoE)
2.2.
SYNCHRONOUS ETHERNET
2.3.
2.3.1 Interfaces
1. GENERAL
2.1.
• 1 PPS / TOD synchronization
• GNSS: GPS/GLONASS
Sour / Dest IPv4 address setting
Dest. MAC address by hand or ARP
DSCP CoS labels, TTL and transport protocol
IP checksum errors insertion
PROTOCOLS
4.2.
•
•
•
•
•
ARP
DHCP
DNS
Ping
Trace route
This Datasheet that contains a specification which are representative and accurate of the product. However, are subject to change without notice
©2014 ALBEDO Telecom
C O N F I D E N T I A L
Datasheet
Datasheet - A L B E D O E t h e r . S y n c
MPLS
4.3.
7.3.
• MPLS generation / analysis
• Double label stack support
• TTL exp, label fields
5. TRAFFIC GENERATOR
8. FRAME ANALYSIS
• Modes: One-way (port A - A), two-way (port A - B)
• Separate statistics for Port A / B, Tx / Rx, Filter
Generation over 8 independent streams
BANDWIDTH PROFILE
5.1.
8.1.
5.1.1 Operation Modes
•
•
•
•
5.2.
Continuous:
Periodic:
Ramp:
Random
223-1, PRBS 231-1 along with their inverted versions, user
(32 bits). These patters apply to stream 1 only
SLA payload
All zeros
Insertion of TSE: single, rate, random
• Frames: unicast, multicast, broadcast
• FCS errors, Undersized, Oversized, Fragments, Jabbers
• Size: < 64, 65-127, 128-255, 256-511, 512-1023,
1024-1518, 1519-1522, 1523-1526 and 1527-MTU bytes
8.2.
(C) ALBEDO TELECOM
• Up to 8 simultaneous filters to be applied to the traffic
• Selection by Ethernet, IP, TCP/UDP fields
• Generic filter by using 16 bit mask and arbitrary offset
6.2.
6.3.
MAC Address: Source and Destination
Type / Length value with selection mask
C-VID and S-VID with selection mask
Service and Customer priority codepoint
8.4.
• Count, seconds, ratio and pattern loss secs at layer 1-4
8.7.
IPv6 Source and Destination address
IPv6 flow label
DSCP
Next Header
•
•
•
•
7. PHY RESULTS
7.2.
OPERATION
9.1.
• Port: single value or or ranges of values
•
CABLE TESTS
•
•
•
•
NETWORK EXPLORATION
• Top talkers: 25 most popular MAC / IPv4 / IPv6 addr
• Top C-VID and S-VID: 25+25 most popular tags
• Atomatic setup of 8 filtering blocks
9. PTP (IEEE 1588)
UDP SELECTION
7.1.
Delay (FTD): current, min, max, mean
Delay variation (FDV or jitter): current, min, max, mean
Reordering: Out-of-order, Duplicated count and ratio
Loss (FLR): count, ratio
Availability: SES count, PEU, PEA
BER
8.6.
IPV6 SELECTION
6.5.
SLA STATISTICS
•
•
•
•
•
IPV4 SELECTION
• IPv4 Source and Destination address
• IPv4 Protocol
• DSCP fields
•
•
•
•
Packet counts: IPv4 packets, IPv6 packets
Packet counts: unicast, multicast and broadcast
UDP packets, ICMP packets
IPv4 checksum errors, IPv6 checksum errors
IEEE 1588-2008 packets
BANDWIDTH STATISTICS
• Current, max, min, avrg (Tx / Rx, Port A / B)
• Unicast, multicast and broadcast counts
• IP and UDP statistics
8.5.
MPLS SELECTION
• Top and Bottom MPLS headers
• Label value
• Exp field
6.4.
IP STATISTICS
•
•
•
•
•
ETHERNET SELECTION
•
•
•
•
MPLS STATISTICS
• MPLS stack size: max, min
8.3.
6. FILTERS
6.1.
ETHERNET STATISTICS
• Counts: Ethernet, VLAN, IEEE 802.1ad frames, Q-in-Q,
Control, Pause, IEEE 1588-2008
TEST PATTERNS AND PAYLOADS
• Layer 1 BER: HF, LF, MF, Long/Short continuous random
• Layer 2-4: PRBS 211-1, PRBS 215-1, PRBS 220-1, PRBS
•
•
•
SYNCHRONOUS ETHERNET
• Frequency (MHz), offset (ppm), drift (ppm/s)
• TIE / MTIE / TDEV
• Decoding of the QL transported in SSM
C O N F I D E N C I A L
2/3
Optical power (over compatible SFP/SFP+)
Inactive links: Open/short, distance to fault
10/100 Mbit/s links: current local port MDI/MDI-X status
1000 Mbit/s links: current, polarities, skew
9.2.
Generation / Decoding of PTP - IEEE 1588-2008
Operation as Ordinary Clock
Master / Slave operations, ability to force Slave role
Transparent operation in pass-through mode with Packet
delay equalization
Encapsulations: PTP over UDP / IPv4, PTP over Ethernet
PROTOCOL STATE
• Port state, best master clock, master identity
• Grandmaster: identity, BMC priorities, clock class, accuracy,
clock variance, time source
AUTO-NEGOTIATION
• Bit rate and duplex mode
• Master / Slave role indication (1000BASE-T)
www.albedotelecom.com
Joan d’Austria, 112
08018 - Barcelona - Spain
[email protected]
in Test we Trust
Datasheet - A L B E D O E t h e r . S y n c
3/3
COUNTS & STATISTICS
• Sync, Delay request, Delay response, Peer delay request,
•
•
•
•
•
•
•
•
C O N F I D E N C I A L
9.3.
Peer delay response, Follow up, Peer delay response follow
up, Announce, Signaling, Management
Sync delay: current, max, min, avg, st-dev, range
Sync delay variation: current, max, avg
Sync inter arrival time: min, max, avg, current
Delay request: current, max, min, avg, st-dev, range
Round trip delay: current, mean
Correction field: current, max, avg
Sync floor delay population: Count (FPC), Rate (FPR), Percent (FPP). Configurable Pass / Fail theshold
Wander: TIE, MTIE, TDEV
10. AUTOMATIC TESTS
Automatic RFC 2544 / Y.1564 tests in one/two ways mode
10.1. PORT LOOPBACK
• Layer 1-4 loopback with Filtering conditions
• MPLS loop control
• Loop controls for broadcast and ICMP
(C) ALBEDO TELECOM
10.2. RFC 2544
• Throughput, Frame-loss, Latency, Back-to-back, Recovery
• Asymmetric RFC based on Ethernet and IP RMP
10.3. Y.1564
• Ethernet service activation
• Eight / four services (colour / not) CIR, EIR, max, througput
• FTD, FDV, FLR, availability objectives
10.3.1 Test Phases
• Phase 1: steps, step duration
• Phase 2: duration, bandwidth profile (deterministic, random)
11. PLATFORM
11.1. GUI
• Touch-screen, keyboard and mouse
• Full remote control with VNC
• SNMP and MIB support
11.2. BATTERIES
• Operation time with batteries (LiPO): 8 - 24 hours
• Battery recharge time (LiPO): 4 hours
11.3.
•
•
•
•
OPERATION
Operational range: -10ºC to +50ºC
Operation humidity: 10% - 90%
IP rating: 54
Configuration, report storage and export through USB
11.4. ERGONOMICS
• TFT colour touch screen (480 x 272 pixels)
• Dimensions: 223 x 144 x 65 mm (8.8 x 5.6 x 2.5 inches)
• Weight: 1 kg
www.albedotelecom.com
Joan d’Austria, 112
08018 - Barcelona - Spain
[email protected]
in Test we Trust
`