564 IronWorks Face Installation Instructions Compatibility IronWorks Face – With Barrier (new) 95400434 564 SS/DF/DLX w Barrier (2014 or Later) 564 HO GS w Barrier (2014 or Later) IronWorks Face – Non‐Barrier (old) 95400432 564 SS/DF/DLX (no barrier) 564 HO GS (no barrier) Packing List Faceplate Upper and Lower Grills Doors (Left and Right) Glass Frame Cover (6) #8 x 3/8” Sheet Metal Screws Sizing Faceplate Width 36 1/8” Height 29 1/8” Depth on Hearth ½” * * This dimension is the minimum depth. The face may be positioned to accommodate different facing depths, making this dimension up to 1” larger. Installation 1. Carefully remove the packaging and lock‐ties from the faceplate and doors. Remove the glass frame from the fireplace (see the Owner’s Manual for details). Attach the glass frame cover to the glass frame following the directions below. Place the cover over the top of the door frame. Push these tabs inwards to lock the cover in place. Page 1 of 4 17601658 — 10/23/14 © Travis Industries, Inc. 564 IronWorks Face Installation Instructions 2. Attach the faceplate to the fireplace as shown below. Slide the face into place and secure with the six included screws. NOTE: These slots are provided to allow the face to be installed off of the fireplace when using tile or other non-combustible facing. Careful front to back and side to side alignment is required to ensure proper door alignment. Page 2 of 4 17601658 — 10/23/14 © Travis Industries, Inc. 564 IronWorks Face Installation Instructions 3. Hang the grills included with this face on the fireplace. Upper Grill Installation Hold the grill at a slight angle and insert it behind the face and in front of the bushings on the fireplace. Line up the upper slots on the grill with the upper bushings on the fireplace. Push the grill in, then down until the grill locks into place. Place the FPX label onto this plate before shutting the grill. Lower Grill Installation Hold the grill at an angle and insert the lower slot over the bushing on the fireplace (both sides). You may need press on the grill to get the tab over the bushing (this prevents the grill from accidentally falling off). Page 3 of 4 Bend the tab outward on both sides. This is the end-stop for the lower grill, it allows the grill to swing forward. 17601658 — 10/23/14 Swing the grill upwards to engage the upper slot. You will need to lift the grill slightly to get it over the bushing. Once in place the grill is held in place by gravity. © Travis Industries, Inc. 564 IronWorks Face Installation Instructions 4. 5. Attach the glass frame to the fireplace. Install the doors as shown below. When closing the doors, make sure to bring them together at the same time to ensure proper alignment. NOTE: Magnets are shipped attached to the face. Take care with the magnets and keep them away from children. NOTE: If the magnets become dislodged from the position in the faceplate, carefully re‐install them. Page 4 of 4 17601658 — 10/23/14 © Travis Industries, Inc.
© Copyright 2018