Clear Roof Sheets Clear Roof Sheets PVC & GRP

Clear
Clear Roof Sheets
Roof Sheets
PVC & GRP
Most older roof sheet
profiles can be identified
and Manufactured to
length.
PVC Fabrications
Briar Hill,
Waterfall,
Cork.
Phone: 021 4885881
Fax: 0214885884
E-mail: [email protected]
021 4885881
Clear PVC Sheets
Installation Instructions
BENEFITS OF Clear PVC
Weatherability
Manufactured from top
quality PVC resins compounded with
stabilisers and inhibitors, to give exceptional UV resistance and weatherability.
Low Maintenance
High gloss surface finish will
not support moss, algae or fungus growth.
Dirt retention is low and it is also resistant
to most chemicals.
Light Transmission
High optical clarity and
in clear form has light transmission
in excess of 80%.Tinted options offer
varying degrees of solar control. Safety
Good fire performance
properties and is self extinguishing.
It is a strong and durable material.
These factors combine to make
PVC a suitable product for use
in domestic, industrial or leisure
applications. PVC "high impact"
sheet is suitable for use in areas at
high risk from hail damage
Description
Code
Available
length
Cover
width
8/3 6ft
836
6 foot
608mm
8/3 8ft
838
8 foot
608mm
8/3 10ft
8310
10 foot
608mm
8/3 12ft
8312
12foof
608mm
8/3 14ft
8314
14foot
608mm
10/3 6ft
1036
6 foot
761mm
10/3 8ft
1038
8foot
761mm
10/310ft
10310
10foot
761mm
10/312ft
10312
12foot
761mm
10/314ft
10314
14foot
761mm
13.5/3 10ft
1310
10 foot
1066.8
13.5/3 12ft
1312
12foot
1066.8
13.5/3 14 ft
1314
14foot
1066.8
Eternit 177x51
17751
6ft6”
TBC
Asbestos profile
Big 6
AP
6ft 6”
TBC
Fiber Cement Profile
FCP
6ft6”
TBC
Mini
mini
6ft
603mm
€ per Sheet
Cutting
PVC sheets can be cut with hand or power tools.
Hand saws with fine tooth blades e.g. metal cutting blades, are suitable. When cutting a PVC
sheet ensure that it is not under any stress and
that it cannot vibrate. Support the sheet close to
the saw and cut at a shallow angle with slow
steady strokes.
Drilling
Holes must not be punched through PVC sheet.
Hand and power drills are suitable. Drill holes at
a slow speed when using a power drill. Use a
masonry bit and support the sheet underneath
the hole position to avoid vibration. Fixings
should be at least 50mm from the end of the
sheet.
Hole Size
To accommodate thermal movement, holes for
fixings should be drilled 6mm greater in diameter
than the fixing shank for sheet lengths up to 2m
and an additional 3.5mm per additional metre
length of sheet. For example, in a 4m long sheet,
holes should be over drilled by 13mm. Failure to
accommodate thermal movement will cause
buckling of the sheet.
Roof pitches must be a minimum of 5o (87mm
rise per metre) to avoid ponding on the roof .
PVC Fabrications
Briar Hill
Ph:021 4885881
Waterfall
Fax 021 4885884
Cork
Email:
info[email protected]