INSTALLATION MANUAL

INSTALLATION MANUAL
EPSVIEW-N8
Electronic module to visualize the Aftermarket Parking Sensors on the Volkswagen Group OEM autoradio rev.3.13
DESCRIPTION
EPSVIEW-N8 is an electronic module easy to install, that allows you to integrate professionally aftermarket parking sensors on the
Volkswagen Group vehicles equipped with the OEM radio.
The device allows to display on the OEM radio of VW group the signalling of the parking sensors as it happens for the OEM parking sensors.
CONNECTIONS
The harness supplied with PARKVIEW is split in 2 sections, the first is composed by 4 wires to connect back the OEM radio of the vehicle.
In the QUADLOCK plug it must to connect:
YELLOW to the +12vdc positive wire
BLACK to the GND negative wire
GREEN to the CAN H
WHITE to the CAN L
PINK to the POWER wire of the park sensor
The diagram above suggests how to manage the connections, the QUADLOCK plug is seen from the wire output side.
The second section of the harness is a kind of extension long 5 mt that must to lay down till the boot where is located the PARK SENSOR device.
Then connect the terminals of the ORANGE (position 6) and GREY (position 1) wires to the 24 ways connector of the PARK SENSOR as above described.
The kit is composed by 2 sensors one for the front the second for the rear. The connections diagram is the same for both.
CAN L
CAN H
Front
Rear
12 VDC
GND
GOLF VII
VW
F
F
BUZZER
PINK
BUZZER
GREY
F5
F5
Park sensor
Park sensor
ORANGE
GREY
ORANGE
PINK
ON / OFF SENSORS MANUAL
A long press (3 sec) of OK button of the steering wheel commands turns on / off the
sensors when car is driving below 10 km/h speed.
ATTENTION
THE PARKING SENSORS UNIT MUST TO BE INSTALLED ABSOLUTELY ON THE RIGHT SIDE OF THE CAR’S BOOT OTHERWISE THE PARKING
OPERATIONS WILL BE DISPLAYED INVERTED!
ATTENTION
DO NOT INSTALL THE BUZZER SUPPLIED TOGETHER WITH THE PARKING SENSORS KIT BUT PLEASE USE THE ONE PRE-CABLED ON THE
HARNESS SUPPLIED WITH PARKVIEW.
Switching on the parking sensors, the leds of the front/rear parkview will generate some red/green flashes, confirming the
right working.
E3
10R-03 1158
Once the connection are done the system is immediately ready to work, each time the canbus line will wake up the LED of EPSVIEWN8 will light GREEN to indicate the correct behaviour of the module.
Then by insert the back gear the ACTIVE PARK will activate, consequently EPSVIEW-N8 will activate the visualizing on the OEM radio.
With some radio it is managed also the MUTE of the radio.
By removing the back gear the visualizing will be interrupted once the vehicle is over 10 kmh.
R 1
3
2
4
5
R 1
3
2
4
5
WARNING!
IF YOU NEED TO INSTAL THE SAME UNIT IN A NEW CAR IT IS NECESSARY TO RESET THE MODULE.
RESET:
1.
WITH THE UNIT POWERED, PRESS AND KEEP PRESSED THE UNIT BUTTON TILL THE LED SWITCH OFF.
2.
WITH THE LED SWITCHED OFF RELEASE THE BUTTON, THE RESET IS DONE.
COMPATIBILITY
CAR
YEAR
VOLKSWAGEN
From 2010
From 2009
From 2009
From 2009
From 2009
From 2010
From 2010
From 2010
From 2009
From 2009
From 2009
From 2009
From 2010
From 2010
From 2009
From 2010
From 2010
From 2012
From 2013
SEAT
From 2011
From 2011
From 2011
SKODA
From 2011
From 2011
2011-2012
POLO
GOLF VI
GOLF PLUS
GOLF VARIANT
SCIROCCO
JETTA
NUOVA TOURAN
NUOVA SHARAN
TIGUAN
EOS
PASSAT
PASSAT VARIANT
NUOVA PASSAT
NUOVA PASSAT VARIANT
PASSAT CC
NUOVO CADDY
MULTIVAN
NEW BEETLE
GOLF VII
ALTEA
LEON
ALHAMBRA
FABIA
ROOMSTER
OCTAVIA
OCTAVIA
From 2013
YETI
SUPERB
From 2011
From 2011
TROUBLESHOOTING
RADIO COMPATIBLE
RCD 310 - RCD 510 - RNS 310 - RNS 510
RCD 310 - RCD 510 - RNS 310 - RNS 510
RCD 310 - RCD 510 - RNS 310 - RNS 510
RCD 310 - RCD 510 - RNS 310 - RNS 510
RCD 310 - RCD 510 - RNS 310 - RNS 510
RCD 310 - RCD 510 - RNS 310 - RNS 510
RCD 310 - RCD 510 - RNS 310 - RNS 510
RCD 310 - RCD 510 - RNS 310 - RNS 510
RCD 310 - RCD 510 - RNS 310 - RNS 510
RCD 310 - RCD 510 - RNS 310 - RNS 510
RCD 310 - RCD 510 - RNS 310 - RNS 510
RCD 310 - RCD 510 - RNS 310 - RNS 510
RCD 310 - RCD 510 - RNS 310 - RNS 510
RCD 310 - RCD 510 - RNS 310 - RNS 510
RCD 310 - RCD 510 - RNS 310 - RNS 510
RCD 310 - RCD 510 - RNS 310 - RNS 510
RCD 310 - RCD 510 - RNS 310 - RNS 510
RCD 310 - RCD 510 - RNS 310 - RNS 510
MIB ENTRY - MIB STANDARD
RCD 310 - RNS 310
RCD 310 - RNS 310
RCD 310 - RNS 310
SWING - RNS AMUNDSEN
SWING - RNS AMUNDSEN
SWING - RNS AMUNDSEN
STANDARD BOLERO - STANDARD PLUS BOLERO STANDARD NAV AMUNDSEN
SWING - RNS AMUNDSEN
SWING - RNS AMUNDSEN
The unit doesn’t carry out any function and the LED is off.
Verify the connections of the power supply.
The correctly powered unit doesn’t carry out any function and the LED is off.
Verify the CANBUS connections.
The unit is connected correctly and the RED LED flashes quickly.
The unit hasn’t been able to synchronize with the CANBUS, contact the distributor.
The unit is connected correctly and the RED LED flashes in an irregular way.
Verify the CANBUS connections.
The unit is connected correctly and the RED LED is lit up.
The unit has carried out the synchronization with the CANBUS but hasn’t been able to identify the vehicle, contact the distributor.
TECHNICAL CHARACTERISTICS
POWER SUPPLY
10/16 VDC
SLEEP MODE COMSUMPTION
<1 mA
WORKING MODE COMSUMPTION
100 mA
Distributed by Laserline Safety and Security Systems s.r.l.
Head office: Via Don Locatelli 51 | 20877 Roncello (MB).
www.laserline.it [email protected]
Phone : 039/682561 Fax: 039/68256248
WARRANCY
THIS PRODUCT IS GUARANTEED FOR 2 YEARS FOR ANY MANUFACTURING DEFECTS.
THE FISCAL DOCUMENT SERVES AS THE GUARANTEE VALIDITY
The information in this guide are purely for information purposes, therefore, are subject to change without notice. At the time of publication the information is correct and reliable. However the manufacturer can not be held responsible for any consequences resulting from errors or omissions in this manual. The manufacturer reserves the right to improve / change the
product or manual without obligation to notify users.
`