OTE-260013 How to adjust your Drag Racing Christmas Tree light settings The factory setting for the lights on your Drag Racing Christmas Tree allows the lights to blink. If you wish to have non-blinking lights, it is possible to change the factory setting so that the lights stay lit continuously. Please read and follow the instructions below to change the light mode. Make sure to save these instructions in case you wish to return the light mode to the factory setting in the future. CAUTION: MAKE SURE UNIT IS UNPLUGGED FROM POWER SOURCE AND BULBS HAVE COOLED TO ROOM TEMPERATURE. FAILURE TO FOLLOW THIS SAFETY CAUTION MAY LEAD TO INJURY AND/OR DEATH. READ AND UNDERSTAND ALL INSTRUCTIONS THOROUGHLY BEFORE PROCEEDING. Fig. 1 1 Fig. 2 Locate the light control box (shown by the red arrow) located on the back of the main light bar behind the staging lights. The box is on the left side (see Fig. 1). Remove the cover to the control box by gently lifting the lid up and then out (See Fig. 2). Fig. 3 2 Fig. 4 Inside the light control box is a circuit board that controls the lights. On the left side of the circuit board is a switch box that contains 8 switches (See Fig. 3). . 3 To set the lights to “all on”, simply locate the 4th switch from the top, (labeled #5), and push the switch to the right (see arrow in Fig. 4 above). When completed, all switches will be pushed to the right position. Replace the box cover, then install bulbs and hang your sign per the instructions included in the box. To allow lights to blink, return switch #5 to the left (on) position.
© Copyright 2018