SWING-III - RimeLite

Remote Radio Sync and control system including HSS-High Sync Speed up to 1/8000sec(Canon)
The Specification Changes on a Product.
SWING III will have Two execution modes. (HSS & NSS)
If a user would like to use HSS, i-flash should be set
1] HSS Mode ( High Sync Speed mode )
- This Mode supports High Sync Speed of
Canon DSLR up to 1/8000sec.
1) Press + buttons for 2sec,
HSS Mode is activated
2) Trigger LED will be flickering
3times shortly if HSS mode is activated,
And it will be flickering whenever pressing
the shutter of Camera.
3) under HSS mode,
Test button’s work is stopped,
And only LED lamp is just flickering 3times
Again to show it is under HSS mode, if a user
use ‘Test’ function.
4) Under HSS mode, all functions( Flash Mains power On/Off, Flash power Up/Down) is stopped for the smooth
Operation with DSLR camera’s TTL.
Swing III Transmitter is reacted only by DSLR’ TTL Driving signal.
5) HSS mode supports the shutter speed of Canon’s DSLR up to 1/8,000 sec.
2] NSS Mode (Normal Sync Speed mode)
1) Press ‘ – ‘ button for 2 sec,
HSS mode is canceled.
2)Trigger LED lamp isn’t turned
it on.
3)Under NSS mode,
All remote functions will work normally.
Whenever pressing each functional button, Trigger LED will flicker just one time.
4)Under NSS mode,
SWING III can support the shutter speed of
Canon DSLR: up to 1/200sec.
The compatible models among Canon Dslr cameras
-Full frame body : all Canon models after Canon 5D
- APS-C body: all Canon models after Canon 1D.
Nikon : all Nikon DSLR models( up to 1/160sec)
The changed operation way
On Transmitter of SWING III
Test Button
Individual Channel(1~6)
1. Press one of flash individual
buttons (1~6), the button LED
lamp is turn it on and it shows
that it is connected with the flash
set the same Channel.
While button LED On, can adjust
the flash power Up/Down.
Battery (1 x AA size)
Group Selection
(Group Channels)
16 channels
Flash Mains Power On/Off
( all flashes which has the
same Group selection is
turning mains power
2. Press one of flash individual
button for 2 sec.
Flash Mains power On/Off of set
the same channel.
Operation Instruction for SWING-III-Receiver
The LED indicator of Operation.
Set the individual No (1~6)
Group Selection (Group Channels)
1. Insert Receiver into the slot of back case as the picture above.
2. To set the group channel should be the same as Transmitter’s Group channel.
3. Set the individual channel among 1~6 selection.
4. after inserting Receiver, Turn the flash power On. (Receiver’s LED indicator should be On.)