Wrist Corsages Hope this is easy to follow – if you have any questions, contact me at any of the details below. Find me: Blog: vickicollins71.wordpress.com Facebook: Vicki Collins Independent Stampin Up Demonstrator Stampin’ Up!: stampinup.net/esuite/home/vickicollins Pinterest: pinterest.com/vickicollins940 Youtube Supplies Needed Stampin’ Up! Creped Filter Paper 129393 - $4.95 Floral Frames Collection 127012 - $45.95 Daydream Medallions Stamp Set 131976 (w) - $63.95 - 126467 (c) - $50.95 Real Red Classic Stampin’ Pad 126949 - $9.95 1/8”Mini Brads 122941 - $9.50 Paper Piercing Tool 126189 - $6.95 Stampin’ Pierce Mat 126199 - $8.95 3/8”Taffeta Ribbon – Whisper White 109070 - $11.95 Big Shot Die-Cutting Machine 113439 - $149.95 Big Shot Magnetic Platform 130658 - $69.95 Standard Cutting Pads 113475 - $15.95 Extra Supplies Needed Non- SU • Hot Glue Gun Step 1 • Grab the Largest Stamp from Pack 1 of the Daydream Medallions Stamp Set. Largest Step 2 • You will need 12 pieces of Crepe Filtered Paper that will fit this image. (2 images per the rectangle sheet of Crepe Filtered Paper, and 1 image per round sheet of Crepe Filtered Paper) • Ink the stamp with Real Red Ink and stamp each piece of the Crepe Filtered Paper with the inked image. • This is what you should end up with: • Each piece doesn’t have to be stamped the exact same, if you find you have some different, it won’t matter, it will add to the individuality of your flower. • Alternatively you can cut 12 pieces and then stamp. • Tip: stamp on the smooth side, you get a better stamp image Step 3 • Place the 4th Floral Frame from the Floral Frames Framelits onto a stamped piece of Creped Filter Paper, lining up the image and run through the Big Shot Machine, using the Magnetic Platform and Standard Cutting Pads. Cut out the 12 pieces. • • • • • 5th 4th 3rd 2nd 1st Step 4 • Layer your 12 pieces of stamped Crepe Filtered Paper onto top of each other, making sure that each piece is layered differently, best to do this on you Paper Piercing Mat as you will placing a hole in the middle. Step 5 • With your paper piercer, place a hole in the middle and place in a 1/8” Mini Brad. Fasten brad at the back. Step 6 • Pick up the 1st layer of Crepe Filtered Paper and squish in your fingers into the middle Step 7 • Repeat with all pieces. Your flower will become thicker as you squish each piece. Step 8 • When all pieces have been squished into the middle, gently ruffle out the pieces to make it look like a blooming flower, leaving the middle pieces a little more squished then the outer pieces. (after a little practice you will find what suits you best) Step 9 • Flip the flower over, and place Hot Glue onto the back in the middle and lay a length of Ribbon on it. Wait for it to dry. The length of Ribbon will depend on what you're using it for. Step 10 Wrist Corsage Completed!
© Copyright 2018